DUPERON FLEXRAKE FP

  • Typically used in wastewater or similar applications where debris can accumulate or wrap around bars.
  • Scraper designed to clean three sides of the bar and cross members, leaving nothing to chance.  
  • All components serviceable above the deck, eliminating confined space entries.
  • Patented FlexLink system flexes and pivots around large debris and removes it.

Frankenmuth, Michigan
MODEL DESCRIPTION The Duperon FlexRake FP is designed for wastewater applications, though it is also used for open channels with clingy debris necessitating Thru-Bar Technology.
TYPICAL APPLICATIONS Wastewater, CSO, SSO, and sites with clingy debris or grit conditions. Also used in pulp/paper mills, prisons, and raw water intakes.
WIDTH 1.5 feet - 10 feet
Single Strand FlexRake configuration available for 18 inch - 24 inch channels
LENGTH 10 feet - 50 feet
ANGLE OF INSTALLATION Ideal 30 degrees from vertical.
Range from vertical to horizontal considered dependent on site.
STANDARD MATERIALS OF CONSTRUCTION Standard: 304 SSTL
Alternative: 316 SSTL
BAR OPENING Greater than .5 inch - 4 inches
STANDARD SCRAPER SPACING Every 2nd link
SCRAPER CONFIGURATION UHMW Full Penetration scrapers
TYPICAL MOTOR 1/3 HP, explosion proof
DRIVE OPTIONS 1/4 HP 3 PH, 230/460 VAC weatherproof
1/8 HP 1 PH, 115/230 VAC weather shield
1/3 HP 3 PH, 230/460 VAC explosion proof
1/3 HP 1 PH, 115/230 VAC explosion proof
STANDARD OPERATING SPEED .5 RPM. Scrapers move 28 inches/minute.
SHIPPING DATA Fully assembled
STANDARD CONTROLS OPTIONS Packages range from simple on/off to enhanced with differential level control. All packages include motor overload protection - contact Duperon Corporation for further details and assistance in selecting the perfect package for your site.
OPERATION OPTIONS Dependent upon package selected, ranging from manual on/off to automated level control.